Note: You can change the programming mode later if needed using the CompactRIO Chassis Properties dialog box. After adding your target to the project, you will be prompted to select which programming mode you would like to use. Please refer to this article to determine if your CompactRIO is capable of using Real-Time NI-DAQmx. Some models of the CompactRIO have an additional user-selectable mode to program in Real-Time NI-DAQmx. If your system is on a remote subnet, you can also select to manually enter the IP address.įigure 2. Select a new CompactRIO system Select the Appropriate Programming ModeĬompactRIO systems have at least two user-selectable modes. Ensure that your system is properly configured with a valid IP address in Measurement & Automation Explorer. Note If your system is not listed, LabVIEW could not detect it on the network. Expand the Real-Time CompactRIO folder and select your system.Figure 1. Add new targets and devices to your LabVIEW project
